Starting Out with Your OmniBook Special Features 8. If the ribbon cables are no longer tucked into the frame, then push them back into the recessed openings with a paper clip, as shown below. Re-insert the keyboard by engaging the four front tabs on the keyboard into the four slots in the computer frame, pressing down on the keyboard as you insert the tabs. Make sure the ribbon cables slide into the recessed openings and do not extend under the keyboard. 9. Close the OmniBook, turn it over, and re-insert the five screws removed in step 3. Do not over-tighten the screws —screw just until you feel resistance. 10. Insert the battery. Connect the ac adapter. 11. Press the reset button. 12.
Install Windows and the original software on the new drive C using the Recovery CD-ROM—see “If you need to reinstall Windows and original software” under Troubleshooting. Also check the README file for instructions. • There are different procedures for Windows95 and Windows for Workgroups. • For other operating systems, re-install the operating system from your own source first, then load the OmniBook-specific software. 13. Restore the files you backed up from the old drive C. In Windows95, use the Backup utility (Start, Programs, Accessories, System Tools, Backup, Restore tab). 1-28