1. Connection Procedure for Remote Access 6.4.3. Sysmac Studio Online Connection Start Sysmac Studio and go online with the Controller. Startup Guide – Remote Access - RT1 Series - P151-E1-02 43 1 Start Sysmac Studio. *If the User Account Control Dialog Box appears at start, make a selection to start Sysmac Studio. 2 Sysmac Studio starts up. Click Connect to Device. 3 The Connect to Device Screen appears. Select Ethernet connection via a hub in the Connection type Field. Set the IP address of the connection destination to 192.168.250.1 in the Connection settings Field.
Uncheck the boxes for both Transfer from Device and Display the Troubleshooting Dialog Box in the Operation after Connection Field. Click Connect. 4 If Controller is in the factory default settings, the dialog box on the right appears. Check the message and click OK. *The message of the dialog box varies with the status of Controller. Check the message and click on an appropriate button to proceed with the processing.