motor drives the webbing to retract to reduce the possible excessive slack of seat belts. ● Keep the lap section of the belt as close as possible to the hip and do not keep it on the waist. REMINDER ● Do not pull out the belt webbing forcibly during motor start-up, otherwise the motor will not disengage. If that happens, pull out the webbing with a greater force and insert the buckle for pretensioning. 01 SAFETY ● After the motor performs seat belt pretensioning, adjust the seat belt if it is too tight. 3. Insert the latch into the buckle until it clicks, and then pull it back to make sure it is firmly locked. Do not fasten the belt with any part of the strap twisted.
High-speed pretensioning In case of emergency braking in situations such as urgent avoidance, front collision, rear collision, side collision, the motor is activated in advance to retract the webbing in a pre-tensioning manner to minimize the impact damage to occupants. REMINDER ● If the seat belt cannot be released, move the seatback slightly backwards until the tension of the seat belt decreases and the locking mechanism unlocks. 4. Adjust the height of the (front) seat belts for optimum comfort and protection. Using Seat Belts ① Press the adjuster release button. ② Move the adjuster up or down to the intended position and release it. 1.
Adjust the seat position and seatback angle (see P56 ). 2. Adjust the position of the three-point seat belt. ● Keeping a proper sitting posture, pull the seat belt out so that it is diagonally across the chest. The belt should not go under the arm or across the back of the neck. 13