Instruments and Controls Follow Me Home Headlamp High/Low Beam Switching After the START/STOP Switch is turned off, pull the lighting stalk switch towards the steering wheel. This will enable the Follow Me Home function, dipped beam headlamps and side lamps will illuminate depending upon the vehicle configuration. It can be set on the entertainment display. 1 With the START/STOP Switch in the ON/ READY position and dipped headlamps are switched on, push the lever (1) towards the instrument panel to turn on headlamp high beams. The high beam indicator lamp in instrument pack illuminates, push the lever (1) again or pull the lever (2) to switch to headlamp low beams.
Headlamp Levelling Manual Adjustment High Beam Flash Main Beam Switch To briefly flash the high beam on and off, pull the lever towards the steering wheel (2) and then release. Take care not to dazzle oncoming vehicles when driving using main beam headlamps. Auto High Beam* The auto high beam system serves only as an auxiliary function. The driver must check the status of the front lamps, and turn on the front lamps when necessary. Position 0 is the initial position of the headlamp levelling adjustment switch. The headlamp levelling adjustment can be made as per the following table according to the vehicle load. For example:
The main beam may not be turned off automatically in the following cases, thus manual switching between the main beam and dipped beam is required: 21 Location Load 0 Driver, or driver & front passenger. 1 All the seats occupied with no load. 2 All the seats occupied plus an evenly distributed load in the boot, or driver with full load. 3 Driver only, plus an evenly distributed load in the boot.