Instruments and Controls • The windscreen is dirty, broken or obstructed by other objects blocking the view of the sensor. display. enabled and the main beam lights are automatically turned on, the high beam switch is operated. In the case of automatic control, the system will automatically turn on the main beam when the surrounding environment is dark and there is no light detected from any vehicles ahead, or oncoming vehicles; when the surrounding environment is bright enough or the system detects the headlamps or tail lamps of the vehicle ahead or oncoming vehicles, the system will automatically turn off the main beam.
• The lamps of other vehicles are missing, damaged, blocked or cannot be detected due to weather and other reasons. • When the auto high beam system is enabled and the main beam lights are automatically turned on, the high beam flash switch is operated. • When pedestrians, non-motor vehicles and other objects with no obvious light or reflected light are encountered. If the system exits, quickly push the direction indicator/main beam switch (main beam ‘ON’) towards the instrument pack twice to enter the auto high beam system again. You can only exit two times in one ignition cycle.
If you exit greater than or equal to three times, you will not be able to enable this function again in the current start cycle. The auto high beam system can be reactivated after the next start cycle. • When the headlamps and tail lamps of other vehicles cannot be detected due to the sensor view being impaired due undulating road conditions such as bends, dips or hills. To enable the auto high beam system, the following conditions must be met: 1 The master lighting switch must be in the Auto position and the dipped beam lamps switched on via automatic control. • When the car is driving on a winding road or mountainous road. 2 The vehicle is running and the speed is above 25mph (40km/h).
The auto high beam system is designed to detect the light intensity information of the vehicle in front using the vehicle forward camera and switch the main beam on or off when certain conditions are met. When the auto high beam system is enabled, the auto high beam indicator in the instrument pack illuminates. After the vehicle is started, the auto high beam system enters the ready state of work. It can be set on the entertainment IMPORTANT If the following conditions are met, the vehicle will automatically exit the auto high beam system.
The auto high beam function uses data from the front view camera, always keep the windscreen clean and free from residue in this area to maintain optimum performance of this system. Any damage in this area, such as stonechips must be repaired at the earliest convenience. • When the auto high beam system is enabled and the dipped beam lights are automatically turned on, the high beam switch is operated. • When the auto high beam system is 22