Instruments and Controls Wipers and Washers Intermittent Wipe Single Wipe With automatic wipe, the vehicle will adjust the wiping speed according to the signals provided by rain sensor. Turn the switch (5) to adjust the sensitivity of rain sensor. As the sensitivity increases, the wiping interval decreases. Pressing the lever (4) down and releasing will operate a single wipe, if the lever is held down, the wipers will operate continuously until the lever is released. Note: When the car is stationary, if the bonnet is opened, the front wiper/washer will stop work immediately. Note: Immediately operating the wiper one time can be achieved by increasing the sensitivity of rain sensor.
If the rain sensor detects continuous rainwater, the wiper will keep working. When no rain is detected, it is recommended to switch off automatic wipe. IMPORTANT • Avoid operating the wipers on a dry windscreen. • In freezing or extremely hot weather conditions, make sure that the wiper blades are not frozen/adhered to the windscreen. Windscreen Wiper Operation The wipers and washers will only operate with the vehicle power system in the ACC/ ON/READY position. Operate the lever to select different wipe speeds: Slow Wipe By pushing the lever up to the slow wipe position (2), the wipers will operate slowly. Move the lever to re-select the wipe speed.
• In winter, remove snow or ice from around the arms and blades, including the wiped area of the screen. • Intermittent wipe (1) • Slow wipe (2) Fast Wipe • Fast wipe (3) By pushing the lever up to the fast wipe position (3), the wipers will operate fast. Move the lever to re-select the wipe speed. • Single wipe (4) • Rain sensor sensitivity adjustment (5) • Programmed wash/wipe (6) 24