Instruments and Controls Sunroof * • DO NOT use abrasive materials to clean the sunroof glass. Use alcohol based solvent. Sunroof Operation The sunroof consists two pieces of glass and one sunshade. The front glass can be opened by sliding or tilting, the rear one is fixed and cannot be opened, and the sunshade can slide open. 1 • DO NOT hold the operating switch in the open/close position for any length of time after operation is complete, this could damage the electrical components. Instructions • Clean the sunroof regularly to maintain operation and performance. Visit an MG Authorised Repairer for service as required.
DO NOT allow passengers to lean out of an open sunroof whilst the vehicle is in motion. Injuries may occur from objects such as tree branches. Safety of the vehicle occupants must be observed at all times. DO NOT allow limbs to be placed in the moving path of the sunroof at any time, injury may occur. When the START/STOP Switch is set to ACC or ON/READY, you can operate the sunroof. Switch 1 is used to operate the sunroof sunshade, and switch 2 is used to operate the sunroof glass. The operational function is identified by the icons on the switches. • Avoid fully opening the sunroof during rain showers. • It is advised not to open the sunroof at high speeds.
• Where possible, please clean any residual water or raindrops off the sunroof prior to opening. Failure to do so may result in water entering the car. 33