Instruments and Controls Linkage between Sunshade and Sunroof Glass Sunroof Initialisation Thermal Protection In the event of a power failure or battery disconnection when the sunroof glass or sunshade is in motion, the sunroof/sunshade will require initialisation when the power is restored. To prevent the sunroof glass motor and the sunshade motor from being overheated and damaged, the motors are designed with a thermal protection function. To prevent the sunshade from being exposed, the sunshade will move together with the sunroof glass as one unit when the sunroof is opened. To close the sunshade, please close the sunroof glass first.
After the thermal protection function is activated, the sunroof/sunshade does not respond to other operations except the closing operation. After the motor has cooled down and exits the thermal protection state, the sunroof can be operated normally until the next thermal protection event. To carry out the sunroof glass initialisation operation: Fully close the glass - gently slide the switch forward to the 2nd position and hold in position for 10 seconds. The sunroof will open a preset amount and stop, it will then close automatically - the sunroof glass is then initiailised. During the whole process, the switch must remain in the 2nd position.
To carry out the sunshade initialisation operation: Fully close the sunshade - slide the close switch forward to the 2nd position and hold in position for 10 seconds. The sunshade will open a preset amount and stop, it will then close automatically - the sunshade is then initiailised. During the whole process, the switch must remain in the 2nd position. 36