CS-150 Quick Reference Guide ARMING BEFORE LEAVING 1, STATUS light must be on. 2. Press LEAVE and your PAC, 3. Controlstation will beep andred ARMED indicator will light. REMOVING ALL BYPASSES 1. ARMING WITHOUT LEAVING (Arming with Interior off) 1. Press STAY. 2. Enter your PAC, ARMING WITHOUT LEAVING (Arming with Interior off and Delay off) 1. Press STAY. 2. Enter your PAC, 3. Press INSTANT. DISPLAY ALARM MEMORY 1. Press 3 and your PAC, 2. The indicator that is lighted indicates the zone that triggered the mostrecent alarm ay (zones 01-08), DISPLAY ZONE 09-16 STATUS 1. Press 2 and your PAC, 2. Press 2 obtain display. LIGHT ON LIGHT OFF LIGHT BLINKING Press LEAVE and your PAC, 3.
The ARMED indicator should go off. BYPASSING A ZONE 1. The system must be disarmed. 2. Press BYPASS and the zone number to 6. The ZONE 01-08 light(s) will blink. (If zone(s) 09- 16, STATUS light will blink. BYPASSING ALL FAULTED ZONES 1. The system must be disarmed. 2. Press BYPASS then 0 plus 0. 3. All faulted zones will blink their corresponding zone indicator. 4. Press [*] . Press 8 again to test zones 09-16. 7. Press[*] when finished testing. be bypassed, 01-16. 3. Press 3 again to display zones 09-16. Reset the blinking ARMED indicator by pressing [X] . TESTING THE ZONES 1. The system must be disarmed. 2. Press 8 and your PAC to test zones 01-08 3.
Violate a zone (open adoor,etc.).Control Station will beep and the corresponding tested zone indicator will light. 4. Restore the tested device to service. The Control station will stop beeping but zone indicator will remain lit. 5. Repeat steps 2-4 for each of the eight zones to be tested, ZONE OPEN ZONE SECURE ZONE BYPASSED DISARMING WHEN ENTERING 1. A steady warning tone will sound. 2; The system must be disarmed. 2. Press BYPASS then 9. 3. The ready light will stop blinking. WHAT TO DO FOR A FALSE ALARM 1, Press LEAVE and your PAC, 2. Alarm should silence. 3. If alarm is still on, press [*] and start over. 4. Notify the appropriate authorities. TESTING THE BATTERY 1.
Press 7 and your PAC, 2. Wait 5 seconds, STATUS LIGHT ON: Battery OK STATUS LIGHT BLINKING: System battery may be weak orcontrol panel fuse blown. PRESS 20 WHEN IN DOUBT, [*] AND BEGIN AGAIN