00 Tightening torques 00.5 Model R 1150 GS Connection Nm 11 Engine Cylinder head Tightening sequence: 1. Tighten cylinder head nuts (oiled) in diagonally opposite sequence 1.1 Tighten all nuts to closing torque 1.2 Tighten all nuts to correct angle 90° 1.3 Tighten all nuts to correct angle 90° 2. M 10 screw 3. M 6 screw 20 40 9 After 1,000 km (600 miles), tighten cylinder head nuts in diagonally opposite sequence: 1. Slacken one nut 2. Tighten nut to initial torque 3. Tighten nut to wrench angle 180° 4.
Slacken and retighten M 10 screw 20 40 Timing gear carrier to cylinder head 9 Bearing cap on rocker shaft 18 Locknut, valve adjusting screw 8 Cylinder head cover to cylinder head 8 Camshaft end cover to cylinder head 9 Air intake connection to cylinder head 9 Camshaft Chain sprocket to camshaft 65 Camshaft bearing cap 15 Alternator mount cover M 6 screw 9 M 8 screw 20 Auxiliary shaft Chain sprocket to crankshaft 10 Chainwheel to auxiliary shaft 70 Chain tensioner housing to engine block 9 Oil filter Oil filter 11 Oil drain plug 32