Checking headlight beam angle, adjusting if necessary Checking tightness of rear wheel studs X Tightening torque: Rear wheel studs ....................................... 105 Nm Checking tyre pressures • Check/correct tyre pressures. Tyre pressures: Solo ..................................... front 2.2 bar (31.3 psi) ............................................. rear 2.5 bar (35.6 psi) Two-up ................................ front 2.5 bar (35.6 psi) ............................................. rear 2.7 bar (38.4 psi) R21000140 Two-up + luggage................ front 2.5 bar (35.6 psi) ............................................. rear 2.9 bar (41.2 psi) • Motorcycle on level surface.
• Rider’s weight on motorcycle • (approx. 85 kg/176 lbs). • Move swivel lever to horizontal position (basic setting). • Turn the adjusting screws to correct the head- light beam throw. Attaching adhesive label • Remove the adhesive label from the package and fix it in position at the bottom of the glass cover of the rev. counter. Lateral adjustment: ........................Adjusting screw on left of headlight Vertical adjustment: ......................Adjusting screw on right of headlight Turn screw anti-clockwise: ............... longer throw Turn screw clockwise:
.....................shorter throw S000080 Setting for headlight beam angle adjuster .................................................... -15 cm (- 5.9 in) .......................... . over a distance of 10 m (32.8 ft) 00.20