Final inspection with road safety and functional check (Inspections I, II, III and IV) Road safety check • Check wheels and tyres. • Check/correct tyre pressures. • Wait at least 10 minutes after the trial run/road test before checking/correcting engine oil level. Tyre pressures: Solo ..................................... front 2.2 bar (31.3 psi) ............................................. rear 2.5 bar (35.6 psi) Two-up ................................ front 2.5 bar (35.6 psi) ............................................. rear 2.7 bar (38.4 psi) Two-up + luggage................ front 2.5 bar (35.6 psi) .............................................
rear 2.9 bar (41.2 psi) R21000350 • Use the adjusting screws (arrow) to adjust play of the throttle cables. • Push the rubber cap into position over the ad- justing screw. Roadworthiness check • Lights • Telltale/warning lights • Horn • Instruments • Special equipment • Clutch • Gear shift • Steering • Foot brake and handbrake • If necessary, take the motorcycle for a test ride. Play of throttle cable: ..... approx. 0.5 mm (0.02 in) R21000360 • Use the adjusting screw (arrow) to adjust play of the choke cable to zero. • Push the rubber cap into position over the ad- justing screw. • Move the handlebars all the way from left to right and check the settings.
Make sure that engine speed does not vary when the handlebars are moved in this way. • Repeatedly open the throttle gradually and in- crease engine speed from idle to approximately n = 2,500 rpm to check throttle-valve synchroni- sation. (Readings shown by Synchro tester must increase and decrease together). If necessary, correct by turning the adjusting screws of the throttle-valve Bowden cable. L Note: Make sure that when the throttle grip is released both throttle valves return to their fully closed posi- tions. • Tighten the locknuts and recheck carburettor balance. • Seal off the vacuum bores. 00.39