Key to maintenance intervals Checking throttle cable play, adjusting if necessary – BMW Inspection 1000 km/600 miles I – BMW Service II – BMW Inspection III – BMW Annual Service IV (Inspections I and III) • Check throttle cable for free movement and free- Reading out MoDiTeC fault memory (Inspections I, II, III and IV) • Remove the left air cleaner trim panel. • Connect MoDiTeC to diagnostic plug. • Read out the fault memory. • Perform any repair work indicated. 00.11 dom from abrasion or kinking; renew if neces- sary. • With the steering turned to various angles, open y the throttle twistgrip fully and allow it to close again.
• When released, the twistgrip must return to the closed position by itself. C000010 • Pull back the protective cap. • Preset throttle cable play with the engine cold to 1.5 mm (0.06 in). • Warm the engine up to its regular operating tem- perature. • Adjust throttle cable play to 0.5 mm (0.02 in). Adjusting value: Initial throttle cable play setting (engine cold) ................................. 1.5 mm (0.06 in) Throttle cable play (engine warm).. 0.5 mm (0.02 in) C000010 C000010