Changing oil in gearbox Changing oil in rear wheel drive; cleaning inductive signal transmitter at rear wheel (Inspections III and IV) or at least every 2 years (Inspections I, III and IV) Every 40 000 km (24 000 miles) or at least every 00.13 • Change the gearbox oil while at regular operating 2 years temperature. • Change the gearbox oil while at regular operating temperature. 3 2 1 5 6 4 C000040 • Loosen clip/trim (1) at right silencer and turn C000050 downwards. • Take out oil filler plug (3) and oil drain plug (2) and e allow the oil to drain out. Caution: • Clean the magnet in the oil drain plug. Note that the interior of the gearbox is slightly pres- • Insert the oil drain plug again.
surised. L • Slacken off oil drain plug (4) so that the pressure Note: drops. Add oil to the gearbox up to the lower edge of the • Unscrew and remove oil filler plug (5). filler hole, then place the motorcycle on its side • Unscrew and remove oil drain plug (4) and allow (prop) stand and add the remaining 0.2 litre the oil to drain out. (0.35 Imp. pint, 0.21 US quart). • Fit new seal and screw in drain plug. • Add gearbox oil. • Add gearbox oil. • Insert oil filler plug with new seal. • Insert oil filler plug with new seal. • Release the fastening, pull out inductive signal X transmitter (6) and clean it. X Tightening torque: Oil drain plug................................................
55 Nm Tightening torque: Oil filler plug ................................................. 23 Nm Oil drain plug................................................ 23 Nm Exhaust pipe clip at silencer (muffler) ........... 55 Nm Oil filler plug ................................................. 23 Nm Fill quantity: Fill quantity: Initial filling.......1.0 l (1.76 Imp. pints/1.06 US quart) Initial filling up to lower edge of filler During hole.........app. 0.20 l (0.35 Imp. pint/0.21 US quart) oil changes......1.0 l (1.76 Imp. pints/1.06 US quart) Oil change up to lower edge of filler hole.........app. 0.20 l (0.35 Imp. pint/0.21 US quart) Oil grade for gearbox:
Brand-name hypoid gear oil, SAE 90, API class GL 5 Oil grade for rear wheel drive: Brand-name hypoid gear oil, SAE 90, API class GL 5 3 2 1 C000040 5 6 4 C000050 C000040 C000050