11.24 1 65 x M8 3 2 RS110090 • Remove camshaft bearing cap (1). • Remove camshaft and bearings (2). • Remove bucket-type tappets. e Caution: Do not accidentally confuse the bucket-type tap- pets. • Reassemble in the reverse order of work. e Caution: Note direction of installation (3) for camshaft bearing cap. The cutout on the rocker shafts must be aligned with the retaining holes. L RS110100 Note: Locate pushrods in ball cups on rockers and hold • Reposition the bearings until minimum endplay is the rockers together with a rubber band to secure obtained. the pushrods in position. End float of rocker: X min............................................ 0.05 mm (0.002 in) Tightening torque:
max. ......................................... 0.40 mm (0.016 in) M 8 screw, rocker shaft bearing cap ............ 15 Nm M 8 screw for camshaft bearing cap ........... 15 Nm RS110100