RS110980 Adjusting valve clearances • Set piston to TDC on the ignition stroke. • Measure valve clearance with feeler gauge. • Correct valve clearance with adjusting screw and lock into position. Valve clearances with engine cold (max. 35 ° C/95 ° F): Inlet........................................... 0.15 mm (0.006 in) Exhaust ..................................... 0.30 mm (0.012 in) X Tightening torque: Locknut.......................................................... 8 Nm • Check valve clearance again; it must be possible to insert the feeler gauge between valve stem and rocker with only slight resistance to move- ment. 11.56