Step 4: Configure Your AMR's Network and Security Settings To access your AMR remotely, you should set up a static IP address for each AMR. The SetNetGo interface allows you to configure your hardware’s Ethernet settings, configure serial and TCP forwarding, and upgrade the on-board software. If you are not familiar with setting up a network or do not have an assigned IP address for the AMR, please see your system administrator. IMPORTANT: If you change any values in a SetNetGo screen, you must click Apply before switching to another sub-screen, or those values will not be saved.
For example, when changing wireless Ethernet settings, be sure to click Apply before navigating back to the dashboard. To configure network settings, click the Network tab at the top of the SetNetGo screen. Figure 4-7. SetNetGo Interface 20569-020 Rev. A Fleet Operations Workspace Core User's Guide 41 Network Menu Description Wireless Ethernet Sets up your wireless Ethernet connection to your AMR, including IP settings, WiFi network settings, security settings, and radio set- tings. User LAN Ethernet This screen has user-configurable settings for interface mode, IP address, netmask, DHCP server for accessories, and DHCP IP range.
RS-232 Port Forwarding Controls forwarding of serial data to a TCP port on the wireless and internal wired Ethernet networks, where the data is re-directed to a TCP port on an IP address accessible via the Wired Ethernet interface (which must be set to accessory mode). There is also port-forwarding for the two extra on-board serial ports to a TCP port on the wireless Eth- ernet interface.