SC-B9580 User's Guide Problem Solver Problem Solver When a Message is Displayed If one of the following messages is displayed, read and follow the instructions below. 100 Messages What to do The waste ink bottle is nearing the end of its service life. Prepare a new one. You can continue printing until replacement is required. The waste ink bottle is getting full. Ready a new waste ink bottle. U “Options and Consumable Products” on page 108 Cannot recognize ink supply unit. Try installing again. Ink supply unit is not recognized. Please replace the XXXXX. XXXXXX represents the target ink color. Install the ink supply unit again.
If the message persists, insert a new ink supply unit (do not reinsert the ink supply unit that caused the error). Ink is low. You can continue printing until replacement is required. The ink is low. Prepare a new ink supply unit for the specified color. U “Options and Consumable Products” on page 108 The heater is warming up. One or more heaters is still being warmed to the specified temperature. To start printing while the heater temperature is low, press Start to display a confirmation screen, and then press OK to start. The media and print head are contacting. Check whether the print results are clean. Printing can continue.
If you check the print results and they are dirty, stop printing and clean around the print head. U “Cleaning Around the Print Head” on page 70 At the same time, refer to "Troubleshooting & Tips" in the Online Manual to take measures so striking does not reoccur. The XXXXX is nearing the end of its service life. The replacement interval is approaching for the parts that are shown. Prepare new parts. The media is not attached to the roll core on the auto take-up reel unit. Attach the media. Media is not correctly attached to the auto take-up reel unit. If this happens while printing, press Pause to stop printing.
Flip the Auto switch on the auto take-up reel unit to the Off position, then flip it back and reattach the media to the auto take-up reel unit. U “Using the Auto Take-up Reel Unit” on page 40