TO INSTALL MOWER Besure tractoris on levelsurfaceand mowersuspensionarmsare raisedwith attachmentlift control.Engageparking brake. 1. Swinganti-swaybarto left side of mowerdeck. 2. Slidemower undertractor withdeflec- tor shieldto rightside of tractor. IMPORTANT:Check beltfor proper rout- ing in all mowerpulleygrooves. 3. If equipped, turn height adjustment knob counterclockwise until it stops. 4. Lower mower linkage with attachment lift control. 5. Be sure belt tension rod is in disen- SIDE-TO-SIDE ADJUSTMENT Raise mower to its highest position. Measure height from bottom edge of mower to ground level at front corners of mower. Distance "A" on both sides of mower should be the same.
If adjustment is necessary, make adjust- ment on one side of mower only. To raise one side of mower, tighten lift link adjustment nut on that side. To lower one side of mower, loosen lift link adjustment nut on that side. NOTE: Each full turn of adjustment nut will change mower height about 3/16". Recheck measurements after adjusting. gaged position. 6. Install belt into electric clutch pulley groove. 7. Place the suspension arms on outward pointing deck pins. Retain with double loop retainer spring with loops up as shown. 8. Install front plate assembly to tractor suspension brackets and retain with single loop retainer springs as shown. 9.
Position front plate assembly between front mower brackets. Raise deck and Bottom Edge of Bottom Edge of Mower to Ground Mower to Ground Suspension Arm plate assembly to align holes and insert flanged pins. Secure pins with double loop retainer springs between the plate assembly and mower brack- ets. Link Adjustment Nut FRONT-TO-BACK ADJUSTMENT NOTE: To assist in locating hole in flanged pin, the hole in pin is inline with notch on head of pin. If necessary, move mower side-to-side to give space between plate and mower brackets. IMPORTANT: Deck must be level side- to-side.
If the following front-to-back adjustment is necessary, be sure to adjust both front links equally so mower will stay level side-to-side. IMPORTANT: Check belt for proper rout- ing in all mower pulley grooves. 10. Engage belt tension rod by pushing rod into locking bracket. A CAUTION: Belt tension rod is spring loaded. Have a tight grip on rod and en- gage slowly. 11. Connect anti-sway bar to chassis bracket under left footrest and retain To obtain the best cutting results, the mower blades should be adjusted so the front tip is approximately 1/8" to 1/2" lower than the rear tip when the mower is in its ,_ghest position. CAUTION: Blades are sharp.
Protect your hands with gloves and/or wrap blade with heavy cloth. Check adjustment on right side of tractor. Position any blade so the tip is pointing straight forward. Measure distance "B" at front and rear tip of blade Before making any necessary adjust- ments, check that both front plate links are equal in length. If links are not equal in length, adjust one link to same length as other link. To lower front of blade, loosen nut "C" on both front links an equal number of turns. NOTE: Each full turn of nut "C" will change with double loop retainer spring. 12. If equipped, turn height adjustment knob clockwise to remove slack from mower suspension. 13. Raise deck to highest position.
TO LEVEL MOWER HOUSING Adjust the mower while tractor is parked on level ground or driveway. Make sure tires are properly inflated (See "PROD- UCT SPECIFICATIONS" section of this manual). If tires are over or underinflated, you will not properly adjust your mower. 20distance "B" by approximately 3/16".