Control panel error messages These control panel error messages are listed alphabetically. Messages are accompanied by the cause of the message and user- level steps to resolve the problem. Table 10. Control panel error messages Message Cause Solution Cleaning Mode. Wait 1-3 Min. The product is running an internal cleaning cycle. Wait for the product to finish the cleaning cycle. The message will clear when the cycle is finished. Fax Busy. Canceled Send The fax line to which you were sending a fax was busy. The product has cancelled sending the fax. Call the recipient to ensure that the fax machine is on and ready. Check that you are dialing the correct fax number.
Check that the redial on busy option is enabled. Unplug the product telephone cord from the wall, plug in a telephone, and try making a call. Plug the product phone cord into a jack for another phone line. See chapter 6, “Troubleshooting. ” ### Is Empty [Enter] To Add The one-touch key or speed-dial code has not been programmed and therefore cannot be added to a group. Press menu/enter to program the one-touch or speed-dial. If you want to program a group- dial, press cancel and use the control panel menu to create a new group. Press cancel if you do not want to program the one- touch or speed-dial. ###:
[Group Name] Phbook/SpeedDial The product is waiting for you to press a programmed one-touch key or enter a speed-dial code to a group-dial code. Begin adding fax numbers to the group-dial code. See “Programming group-dial codes” in the User Guide on the product CD. 50 Fuser Error The product has experienced an internal hardware error. Disconnect the power cable from the product, wait at least 20 minutes, then reconnect the power cable and wait for the product to initialize. Try another power source. If the message does not clear, see chapter 6, “Troubleshooting.” 38 Chapter 2 - Operation EN