Chassis system Sincerely convinced Specific steps and fault diagnosis: 1. Lift and support the front of the car. 2. Shake the wheel and observe whether the front wheel bearing is loose. 3. Rotate the wheel and observe whether the wheel can rotate smoothly and quietly. 4. Remove the front wheel.(see tire and wheel) 5. Remove the front brake caliper and retainer plate.(refer to "brake system caliper removal and installation") 6. Install a suitable dial indicator holder or similar device on the wheel hub, then push and pull the wheel hub.Measure the axial clearance between the wheel hub and the front wheel bearing assembly.If the axial clearance exceeds 0.05mm, replace the front wheel bearing.
7. Install the front brake caliper and retainer plate. 8. Install the front wheels and lower the vehicle. 2.1.1.3.3 Ball joint inspection of tie rod Note: For the inspection on the lift or trench, the plastic guard plate at the lower part of the 30 Fixed support of dial indicator Dial indicator