WARNING Do not put any object into the sunshade inlet port as this may result in improper operation or damage the sunshade. To avoid personal injury, keep your hands, fingers and head away from the sunshade arm, the arm rail and sun- shade inlet port. Do not hang any object on the arm rail as this may result in improper operation or damage the sunshade. Do not allow children near the rear sun- shade system. They could be injured. Do not place objects on or near the rear sunshade. This could cause improper operation or damage it. Do not forcefully pull the sunshade. Do- ing so may elongate the sunshade. Im- proper operation or damage to the sun- shade may result.
Do not pull or push the rear sunshade. This could cause improper operation or damage it. Restarting the sunshade switch Panoramic sunshade LIC2228 If the sunshade does not operate properly, per- form the following procedure to initialize the sun- shade operation system. The panoramic sunshade operates when the ig- nition switch is in the ON position. The sunshade switch is located near the roof console. When opening or closing the sunshade the switch need not be held. CAUTION 1. Switch the vehicle ignition to the ACCES- SORY or RUN mode. Do not place objects (such as newspa- pers, handkerchiefs, etc.) on the sun- shade inlet port.
Doing so may entangle these objects in the sunshade when it is extending or retracting, causing im- proper operation or damage to the sunshade. 2. Press and hold the sunshade close switch. 3. Sunshade will begin moving towards the close position only while the switch is con- tinually pressed. (this disables the obstacle detection). To open the sunshade: To fully open the sunshade, push the switch 1 toward the open position. Do not push the sunshade arm with your hands, etc., as this may deform it. Improper operation or damage to the sunshade may result. 4. Sunshade will stop for about 4 seconds. To close the sunshade: 5. Sunshade drive cable will travel in the open direction for .394 in.
(10 mm) then reverse direction and stop at the normal close posi- tion. To fully close the sunshade, push the switch 2 toward the close position.