58 c IMPORTANT • Paper with holes or cutouts cannot be used. • Auto cutting on the perforated lines will generate scraps of paper that may cause problems. Also, auto cutting ahead of the perforated line may cause problems when feeding paper. Therefore, perform auto cutting 0.5 to 1 mm behind the perforated line. • Set the black mark position 2 mm or more from the perforated line. • For the black mark position of the die-cut label paper, match the label leading edge to the black mark leading edge. • Use uncut perforations on both sides of the paper. • Both types, paper without waste part and paper without the left and right waste parts, can be used.
• Providing a black mark on both sides enables the paper to be used even when inserted from either side. Paper feed length Mark center position Paper width direction Paper width center center Mark Black mark position when interval inserted in reverse direction Mark Perforation position Normal black 2 mm or mark position more Fanfold paper Mark width Backing paper Label Q Note Depending on the shape of die-cut labels, the labels may peel off their backing paper inside the printer. When you want to use die-cut labels that do not meet the specifications, contact qualified service personnel for advice.