Buzzer The buzzer beeps when an error occurs (when the ERROR LED lights or flashes). Also, you can change whether or not the buzzer beeps for an error (see "Buzzer Setting at the Time of Errors" on page 71 ), and can set the buzzer to beep when printing finishes (see "Autocutting and Buzzer Setting after Printing" on page 72 ). Frequency, volume, pattern, and repeat count can be changed for each printer status using control commands. The default settings are described in the table below. For the relationship between the buzzer frequency and volume, see the table below. *The above values are the center values of the measurement.
22 Printer status Frequency Volume Pattern Repeat count Fatal error 1200 Hz Loud 0.2 s 0.2 s Unlimited Maintenance requirement 840 Hz Cover open 1200 Hz 7 s 1 s Time to replace ink cartridge 1200 Hz 0.5 s 0.5 s Roll paper out 840 Hz Frequency Volume: Soft Volume: Loud 840Hz 50 dB 62.5 dB 1200Hz 38 dB 52 dB