TM-J9000/J9100 Technical Reference Guide Note: To remove the pocket unit, place the printer vertically as shown in the illustration below. Then, while pushing up the lever on the bottom of the pocket unit, push the pocket unit backward. Finally, pull it up to remove it. Lever Figure 2-10 Removing the pocket unit 2.4.3 Connecting the Printer Power Supply WARNING: Be sure to use the EPSON PS-180 power supply unit. Using an incorrect power supply unit may cause fire or electrical shock. 1. Make sure the printer’s power switch is turned off. 2. Check the label on the power supply to make sure the voltage required by the power supply matches your electrical outlet. 3.
Plug the DC power cable into the power supply connector. Power supply connector Figure 2-11 Connector for the power supply Note: To remove the DC power cable, make sure the power supply’s power cord is not plugged into the electrical outlet; then grasp the connector at the arrow and pull it straight out. 4. Turn on the power with the power switch. The POWER LED will come on. Rev. F Setup 2-7 ➁ ➀