Chapter 1 Product Overview Speed of Each Processing Mode This is the processing speed from the point that the first cut sheet is sent from the ASF until receipt of the image data of the 100th cut sheet (highest value). Processing Speed Conditions The processing speed may be reduced by the conditions described below.
• Host computer operating environment ( U “Operating Environment” on page 53 ) • Software that coexists on the computer • Image resolution, light source settings When the resolution of the captured image is 240 dpi or 300 dpi, or when the acquired image is 24-bit color or infrared (IR) • Driver IQA, OCR, bar code recognition settings • Data transfer, save, and other application processing 1 • Cut sheet status • Processing mode and judgment subject 31 Processing modes Judgment made by Condition details High-speed mode Firmware Operation based on firmware judgments, without instructio n from the host computer, for high-speed processing.
However, when cut sheets are output to the sub-pocket in the case of 2- pocket models, processing is slower due to generation of bac k feeding. Driver When driver judgment is required, processing speed is slower compared to operation according to judgment conditions b y firmware only. Confirmation mode Application Since the product stands by for instructions from the applica- tion for each cut sheet scan, processing speed depends on control from the application. Also, processing speed depend s on whether or not overlap is performed.