76 LCD display Error name Error details Solution Cut sheet feed error Double-feed of cut sheets. This could be due to the rea- sons below. • Cut sheets were inserted upside down or back- wards • Confirmation mode is configured so this condi- tion causes an error • Generation of noise by MICR was detected • Specified print data is lon- ger than the cut sheet length • If cut sheets were inserted upside down or back- wards: Orient cut sheet s correctly when loadin g them. (U “Loading Cut Sheets ” on page 63) • When the confirmation mode is configured so this condition causes an error: Follow the instructions provided by the applica- tion. • When generation of noise by the MICR was detected:
Scan again. • When the specified prin t data is longer than the cut sheet length: Specify print data that i s shorter than the length of the cut sheets. Cartridge recognition error Ink information writing is no t be performed correctly. Check if the ink cartridge is installed correctly. (U “Installing the Ink Car- tridges” on page 39) Or you should replace the ink cartridge with a new one. (U “Replacing the Ink Car- tridges” on page 61)