Ultra160 Family Manager Set User’s Guide Installing the Driver When Installing Windows NT The adpu160m.sys driver is not embedded on the Windows NT 4.0 installation disks (or CD-ROM) and must be added during Windows NT installation. Completing a Fresh Windows NT 4.0 Installation From Floppy Disk 1 Create the Windows NT driver disk. For more information, refer to the Creating Family Set Driver Disks section of the Family Manager Set QuickStart Guide . 2 Start your system with the Windows NT Boot Disk in the floppy disk drive. 3 When prompted, insert disk #2 in your floppy disk drive. After a few moments you will see a blue screen. To setup Windows NT now, press Enter .
4 Press S to skip auto-detection of your SCSI host adapter. 5 Press S again to specify an additional device. 6 Press Enter to select Others ; insert the Ultra160 Family Manager Set disk for Windows in your floppy disk drive. 7 Using the arrow keys, select the following driver and press Enter : 8 To add other host adapters that are not part of the Ultra160 Family, press S and repeat from Step 5 for each additional adapter and insert the appropriate driver disk. The Adaptec Ultra160 Family host adapters use the same driver; it is not necessary to install the driver again. Adaptec Ultra160 Family PCI SCSI Controller (NT4.0) 9 Press Enter to continue with the Windows NT operating system setup.
Follow the instructions on-screen and in the Windows NT documentation to complete the installation. 2-2