AVP BackPlane Output Window a. License Key Detection - When the AVP Backplane is launched, it first looks tor the HASP Software License. This can be seen in top two rows. The critical information is that it has found the license and detected that Visionscape GigE (x8) is detected. b. GigE Vision System Creation – The next step once is has found the GigE license is to create the GigE Vision System to contain all the discovered cameras. In this case, the system is called GigEVision1 . c. Adding Cameras to GigE System – In the next step, all discovered cameras are added to the GigEVision1 system. A single system can have up to a total of 8 cameras, Cameras 1-8 (Channel 0-7).
Cameras can be a mix of USB 3.0 and GigE. d. Warnings and Errors – Any informational warnings will be printed into the Backplane Output window in Yellow. Any errors will be printed into the Backplane in Red. 5.3 - Programming and Running AutoVISION/Visionscape with USB 3.0 Cameras 1) Front Runner Taking control of the System After Visionscape FrontRunner launches, the GigE vision system can be programmed by selecting the GigEVision1 icon, and then creating a new job. The camera channel to take the picture from can be selected by clicking on the Snapshot Step in the left-hand list and then selecting the Acquire Tab on the right side. The cameras will go from 1 to 8.
Using Sentech STC-M Cameras with AutoVISION and Visionscape Page 21 of 35