2) Viewing Job in the Job Editor Selecting the Editor Button in the top right of the screen will show the job view. Clicking on the GigEVision1 vision system step will allow you to see the cameras as well as the number of buffers set for each. The default is 16. When using multiple large cameras, it is advisable to set these down to 4 to keep BufferPool memory usage under 200MB. 3) Running the Job Once the job is programmed, it can be put into Run Mode. The Run Mode screen will tell you if there are any GigE bandwidth issue. Typically, you will see FIFO errors, or the acquisition will stop. Using Sentech STC-M Cameras with AutoVISION and Visionscape Page 22 of 35