Page 5 of 190 Report No.: 6068396.50 Test item particulars: Equipment mobility ................................................. : movable hand-held stationary fixed transportable for building-in Connection to the mains ..........................................: pluggable equipment direct plug-in permanent connection for building-in Environmental category ...........................................: outdoor indoor indoor unconditional conditional Over voltage category Mains ...................................: OVC I OVC II OVC III OVC IV Over voltage category PV ........................................:
OVC I OVC II OVC III OVC IV Mains supply tolerance (%) ......................................: -80% / +119% Tested for power systems ........................................: TN, IT IT testing, phase-phase voltage (V) ..........................: 800 Class of equipment ..................................................: Class I Class II Class III Not classified Mass of equipment (kg) ............................................: 99 kg Pollution degree .......................................................: Outside PD3; Inside PD2 IP protection class ....................................................: IP66 Possible test case verdicts:
- test case does not apply to the test object ..............: N/A - test object does meet the requirement ...................: P (Pass) - test object does not meet the requirement .............: F (Fail) - this clause is information reference for installation .: Info. Testing: Date of receipt of test item .......................................: 2019-10-30 (samples provided by applicant) Date (s) of performance of tests ...............................: 2019-10-30 to 2019-12-26 General remarks: The test results presented in this report relate only to the object tested. This report shall not be reproduced, except in full, without the written approval of the Issuing testing laboratory.
The measurement result is considered in conformance with the requirement if it is within the prescribed limit, it is not necessary to account the uncertainty associated with the measurement result. The information provided by the customer in this report may affect the validity of the results, the test lab is not responsible for it. This report is not used for social proof function in China market. "(see Enclosure #)" refers to additional information appended to the report. "(see appended table)" refers to a table appended to the report. Throughout this report a comma / point is used as the decimal separator. TRF No. G99/1-4_V1.0