Precautions for Correct Use Maintenance • If a large dust attaches to the image sensor, use the blower brush (for the camera lens) to blow it off. Do not blow it off with your exhaled air. • Do not use thinner, alcohol, benzene, acetone, or kerosene to clean his product. • When the lens is not being mounted, be sure to attach the C mount cap to the lens mounting part. If a dust attached to the image sensor, the product may sense incorrectly or be broken. • If you do not use the power and I/O cable connector on the back of the camera, always attach the cap for the connector. • Wipe off dirt on this product with a soft cloth gently.
• Before performing maintenance and/or checkup, always turn off the power. Failing to do so may re- sult in electric shock. Image sensor For this product, a line may appear depending on the measurement condition or sensitivity because of the specification of the image sensor. However, this is not a fault or failure of the product. In addition, although there may be multiple defective pixels, this is not a fault or failure of the product. Use the product as confirming the actual image. Others • Never attempt to wrap the camera body with cloth, for example during operation, for example to try to prevent the temperature inside the camera from rising.
• If security software is installed on the PC, the camera connection may be interrupted. Disable the security software settings temporarily and check if the camera can be connected. 12 FJ Series (Camera & Software Vision Package) PC Vision System Camera Setup Guide (Z428-E1)