●Measurement Range and Field of View ●Dimensions Refer to the section 3-2-1 in the Vision System FH Series Hardware Setup Manual for 3D Robot Vision (Cat. No. Z436). 3.2. Workpiece Use the following information as a guide to determine whether a part is measurable. Note that this guide is not a guarantee. Test thoroughly to make sure that it is measurable.
35 Characteristics Measurable Unmeasurable Surface characteristics Matte to weak luster Pattern reflects moderately from all surface Mirror surface, strong gloss, transparent, translucent Pattern is completely reflected or absorbed Surface shape Narrowest width of the surface is more then 10 mm Shapes on which pattern light does not break or warp Holes and steep unevenness, dominant width is less than 10 mm. Pattern light is interrupted Exterior size Dimensions ≥ 40 × 40 mm Thickness ≥ 5 mm Area and height required to obtain sufficient 3D features for recognition Dimensions