10-116 A/C system 10. A/C and Safety System 10.1.10.11 Removal and refitting of front evaporator inlet pipe assembly (EV) Removal procedure 1. Turn off all electrical appliances and the start switch. 2. Disconnect the battery negative terminal (refer t o 3.1.6.1 Maintenance and inspection of battery ) 3. Recover the refrigerant (refer to 10.1.12.12 Recovering/adding refrigerant) 4. Removing the engine compartment left and right front trim panel assemblies (refer to 8.6.6.20 Removal and refitting of engine compartment left front trim panel （ EV ） 5.
Remove the left and right rear trim panel assemblies of the engine compartment (refer to 8.6.6.12 Removal and refitting of engine compartment rear trim panel assembly ) 6. Remove the wiper cover plate. See 8.6.7.9 Removal and refitting of wiper cover plate 7. Remove the A/C air inlet duct assembly (refer to 10.1.11.1 Removal and refitting of A/C air inlet duct assembly ) 8. Remove the front compartment high pressure box (refer to 4.5.8.2 Removal and refitting of engine compartment HV box assembly) 9. Remove the A/C exhaust pipe assembly (refer to 10.1.10.5 Removal and refitting of compressor exhaust pipe assembly) 10. Remove the front evaporator outlet pipe assembly. a.
Unscrew the fixing bolt A of the front evaporator inlet pipe assembly. b. Disconnect the front evaporator inlet pipe assembly from the battery cooling module A/C inlet pipe assembly B Tightening torque of bolt: 8±1Nm. CAUTION: – Sealing pipeline connectors. VOYAH FREE