Routine Maintenance Cleaning the Washable Filter 3. Remove the filter as shown in the diagram, forcefully shake it to remove excess water, then place it aside to dry before reinstalling it. Note: Remove the pad from the mopping module before cleaning it, and make sure dirty water does not flow back into the water outlet to avoid clogging. Do not press too hard on the mop pad, as this can hinder its performance. Pad should be cleaned before each use. It is recommended to change the mop pad every 3 to 6 months. Side Brush 2. Clean and dry the mop pad. 1. Open the dust compartment cover at the positions marked with arrows. Note: Filter must be fully dry before use (allow at least 24 hours). 1.
Flip the vacuum-mop over, then gently pull out the side brush as shown in the diagram below to clean it. 2. Reinstall the side brush. Note: Biweekly cleaning is recommended. Note: It is recommended to clean the side brush monthly and replace every 3 to 6 months. Omnidirectional Wheel 1. Flip the vacuum-mop over and pull out the omnidirectional wheel. 2. Remove hair, dirt, and other debris from the wheel and axle. 3. Reinsert the wheel and press it firmly back into place. 2. Add clean water to the dust compartment, and close the dust compartment cover, then shake the compartment back and forth, finally pour out the water. Repeat these steps until the filter is clean. Note:
Only clean water should be used to clean the filter. Do not use detergent. Do not atempt to clean the filter with a brush or finger. Note: The wheel can be cleaned with water and reinstalled afer drying. Mop Pad 1. Pull the mop pad off of the mopping module to remove it. Wheel Note: The mop pad should be cleaned afer each use. Axle Holder 13 14