Brought to you by BirfMark : PARTS LOCATION : RELAY BLOCKS : CONNECTOR JOINING WIRE HARNESS AND WIRE HARNESS : GROUND POINTS : SPLICE POINTS 89 Brought to you by BirfMark SYSTEM OUTLINE WITH THE IGNITION SW TURNED ON, THE CURRENT FLOWS TO TERMINAL 1 OF THE LIGHT RETAINER RELAY THROUGH ECU-IG FUSE. VOLTAGE IS APPLIED AT ALL TIMES TO TERMINAL 8 OF THE LIGHT RETAINER RELAY THROUGH THE TAIL RELAY (COIL SIDE), AND TO TERMINAL 7 OF THE LIGHT RETAINER RELAY THROUGH THE HEAD RELAY (COIL SIDE). 1. NORMAL LIGHTING OPERATION WITH THE LIGHT CONTROL SW TURNED TO TAIL POSITION, A SIGNAL IS INPUT INTO TERMINAL 2 OF THE LIGHT RETAINER RELAY.
ACCORDING TO THIS SIGNAL, THE CURRENT FLOW TO TERMINAL 8 OF THE RELAY FLOWS THROUGH TERMINAL 2 TO TERMINAL 2 OF THE LIGHT CONTROL SW →TERMINAL 11 → GROUND, CAUSING TAILLIGHTS TO TURN ON. WITH THE LIGHT CONTROL SW TURNED TO HEAD POSITION, A SIGNAL IS INPUT INTO TERMINAL 3 OF THE LIGHT RETAINER RELAY. ACCORDING TO THIS SIGNAL, THE CURRENT FLOW TO TERMINAL 7 OF THE RELAY FLOWS THROUGH TERMINAL 3 TO TERMINAL 13 OF THE LIGHT CONTROL SW →TERMINAL 11 → GROUND, CAUSING HEADLIGHTS AND TAILLIGHTS TO TURN ON. THE TAILLIGHT CIRCUIT IS SAME AS ABOVE (SEE ). 2.
LIGHT AUTO TURN OFF OPERATION WITH THE LIGHTS ON AND THE IGNITION SW TURNED OFF (INPUT SIGNAL GOES TO TERMINAL 1 OF THE LIGHT RETAINER RELAY), WHEN THE DOOR OF DRIVER’S SIDE IS OPENED (INPUT SIGNAL GOES TO TERMINAL 5 OF THE LIGHT RETAINER RELAY), THE RELAY OPERATES, AND THE CURRENT IS CUT OFF WHICH FLOWS FROM TERMINAL 8 OF THE RELAY TO TERMINAL 2 AND FROM TERMINAL 7 OF THE RELAY TO TERMINAL 3. AS A RESULT, ALL LIGHTS ARE TURNED OFF AUTOMATICALLY. SERVICE HINTS L 1 LIGHT RETAINER RELAY 1-GROUND : APPROX. 12 VOLTS WITH THE IGNITION SW AT ON POSITION 6-GROUND : ALWAYS APPROX. 12 VOLTS 5-GROUND : CONTINUITY WITH THE DRIVER’S DOOR OPEN 7-GROUND : ALWAYS APPROX. 12 VOLTS 8-GROUND : ALWAYS APPROX.
12 VOLTS 3-GROUND : CONTINUITY WITH THE LIGHT CONTROL SW AT HEAD POSITION 2-GROUND : CONTINUITY WITH THE LIGHT CONTROL SW AT TAIL OR HEAD POSITION CODE SEE PAGE CODE SEE PAGE CODE SEE PAGE C14 24 F 8 22 L 1 25 D 7 24 F11 25 D16 26 J 7 25 CODE SEE PAGE RELAY BLOCKS (RELAY BLOCK LOCATION) 1 20 R/B NO. 1 (LEFT KICK PANEL) 2 18 R/B NO. 2 (FRONT SIDE OF LEFT FENDER) CODE SEE PAGE JOINING WIRE HARNESS AND WIRE HARNESS (CONNECTOR LOCATION) EA1 30 COWL WIRE AND ENGINE ROOM MAIN WIRE (LEFT FENDER) EA3 1D2 32 COWL WIRE AND FLOOR NO.
1 WIRE (LEFT KICK PANEL) CODE SEE PAGE GROUND POINTS LOCATION ID 32 LEFT KICK PANEL CODE SEE PAGE WIRE HARNESS WITH SPLICE POINTS CODE SEE PAGE WIRE HARNESS WITH SPLICE POINTS E 7 30 ENGINE ROOM MAIN WIRE I 1 32 COWL WIRE