HOME 2.21 HANDLEBARS: VRSCF Figure 2-48. Handlebar Assembly (VRSCF) INSTALLATION 1. See Figure 2-48 . Mount handlebars (7) on upper triple clamp. Tighten handlebar fasteners (8) to 41-47 Nm (31- 35 ft-lbs). 2. Mount the instrument cluster housing (6) by installing the two screws (5) that secure the housing to the handlebars (7), tighten screws to 4-7 Nm (35.4-62.0 in-lbs ). 3. Install instrument cluster (3) and connect wiring harness to instrument cluster. See 7.22 INSTRUMENT CLUSTER: VRSCF . 4. See Figure 2-49 . Install headlamp and tighten headlamp bracket fasteners (2) to 11-18 Nm (9-13 ft-lbs). 2-50 2009 VRSC Service: Chassis 1. Remove right side cover and maxi-fuse. See 7.4 MAXI- FUSE.
2. Remove headlight. See 7.11 HEADLAMP: VRSCAW/VRSCF. 3. Remove throttle cables from throttle control. See 2.10 THROTTLE CABLES. 4. Remove front brake master cylinder/reservoir, turn signal assembly, and throttle control from right handlebar. See 2.15 FRONT BRAKE MASTER CYLINDER/RESERVOIR. 5. Remove switch housing from right handlebar. See 7.30 RIGHT HANDLEBAR SWITCH. 6. Remove clutch master cylinder/reservoir, turn signal assembly from left handlebar. See 2.11 CLUTCH MASTER CYLINDER AND RESERVOIR. 7. Remove switch housing from left handlebar. See 7.31 LEFT HANDLEBAR SWITCH. 8. See Figure 2-48Remove wiring harness connector to instrument cluster and remove instrument cluster (3).
See 7.22 INSTRUMENT CLUSTER: VRSCF. 9. Remove the two screws (5) securing the instrument cluster housing (6) to the handlebars (7) and remove housing. 10. Remove fasteners (8) holding handlebars (7) to upper triple clamp. Remove handlebars. 11. If necessary, remove the handgrip. sm06180 1 5 2 3 4 6 7 8 1. Screw, instrument cluster bezel (4) 2. Bezel, instrument cluster 3. Instrument cluster 4. Boot, reset switch 5. Screw, instrument cluster housing to handlebars (2) 6. Instrument cluster housing 7. Handlebars 8. Fasteners, handlebar mount (2)