HOME NOTE If drive sprocket bearing surface is rough or if bearing is leaking grease, replace bearing in according to procedure. See 2.26 REAR WHEEL, Cleaning and Inspection . is04678 1 2 3 4. See Figure 2-76 . If necessary, remove screws (5) and lockwashers (3) holding compensator bowl (2) to disc wheel (1). Remove compensator bowl (3). 5. If necessary, remove fasteners (19) that hold brake disc (16) to disc wheel (1) and remove brake disc (16). CLEANING AND INSPECTION TOOL NAME PART NUMBER HD-48921 REAR WHEEL COMPENSATOR SPROCKET BEARING REMOVER/INSTALLER 1. Base 2. Sleeve 3. Driver BASE HD-48921-2 DRIVER HD-48921-3 Figure 2-79.
Rear Wheel Compensator Sprocket Bearing Remover/Installer (HD-48921) SLEEVE HD-48921-4 1. Thoroughly clean all parts (except wheel bearings, or wheel speed sensor if ABS equipped) in solvent. Wipe bearings or ABS sensors with damp cloth and inspect for wear. 5. Place parallel press blocks on deck of arbor press. Leave gap between press blocks to accommodate base pin in the next step. NOTE The wheels are aluminum and do not have a protective coating. Damage from harsh chemicals, acid based wheel cleaners, 6. See Figure 2-80 . Position Base BASE (Part No. HD-48921- 2) on press blocks with the large OD topside. Slide Sleeve SLEEVE (Part No. HD-48921-4) over base pin. 2. Inspect rear belt.
See SPROCKETS . 3. Inspect sprocket bearing. If bearing surface is rough or if bearing was leaking grease, replace sprocket bearing as follows: is04674 4. See Figure 2-79 Obtain the Rear Wheel Compensator Sprocket Bearing Remover/Installer REAR WHEEL COMPENSATOR SPROCKET BEARING REMOVER/INSTALLER (Part No. HD-48921). 2 1 1. Base 2. Sleeve Figure 2-80. Base and Sleeve Set for Bearing Removal 2009 VRSC Service: Chassis 2-67 nce can occur. Use (Part No. 94658-98) t use Harley Gloss (P m wheel surfaces. Harley- 7. See Figure 2-81. With the inboard side o clean sprocket over sleeve until it rests on base art No. of Driver DRIVER (Part No.
HD-48921-3) contact is made with extended inner race AND 8. Center arbor under ram and apply press drops into base. Disassemble tool and di 1.17 REAR BELT IVER (P art No. HD-48921-3)