HOME Figure 2-144. Bearing Puller Based on Universal Wedge Attachment (typical) Replace both bearing assemblies even if one assembly appeares to be good. Mismatched bearings can lead to excessive wear and premature replacement. (00532b) Lower Fork Stem Bearing 1. See Figure 2-144. Assemble a bearing puller using a using a UNIVERSAL WEDGE ATTACHMENT (Part No. HD- 95637-46A) , two lengths of threaded rod, washers, nuts, a cross clamp or bridge, and a forcing screw and a washer or protective cap. 2. Turn forcing screw to remove bearings and seal from lower triple clamp. Steering Head Bearing Race 1. See Figure 2-145. With the tapered side down, seat STEERING HEAD BEARING RACE REMOVER (Part No.
HD-39301-A) on upper bearing race leaving a gap in middle and with lower lip of removers capturing bottom edge of bearing race. 2. Install collet on driver. 3. Insert UNIVERSAL DRIVER HANDLE (Part No. HD- 33416) at bottom of steering head tube, and while holding remover tool on race, center collet in gap between remover halves. Tap driver to remove upper race. 4. Reverse tool and repeat procedure to remove lower bearing race. sm03173 sm03177 1 2 3 1. Remover (2 halves) 2. Collet 3. Driver Figure 2-145. Race Remover T HD-39301-A ce: Chassis ools (HD-33416 and )