HOME Always remove the bearing/bushing from the inside of swingarm going outward (see arrows).When installing rear bearings/bush- ings, install from the outside going inward (see arrows). NOTE NOTE When installing bearing, hold the end of the tool without the bearing stationary, and tighten the end with bearing installed. 6. Tighten tool until bearing seats in swingarm housing. DO NOT overtighten. 1. Remove rear swingarm. See 2.38 SWINGARM, Removal . NOTE When mounting swingarm in holding device, protect swingarm to avoid finish damage. 7. Loosen and remove tool. 8. Check swingarm bearing for free movement. 2. Place swingarm assembly on a suitable work surface in suitable holding device.
sm03194 Left Side Swingarm Bearing Removal 1. See Figure 2-155 . Position Remover Cup against inner left arm of swingarm with cupped side facing swingarm 2. Install forcing screw through small hole in Remover Cup. 3. Install SWINGARM BEARING INSTALLATION TOOL (Part No. HD-47175), bearing, washer and nut. 4. Tighten forcing screw until bearing pulls free from swingarm housing. 5. Once bearing has been removed from swingarm, disas- semble tool and remove components from swingarm. Discard old swingarm bearing. Figure 2-156. Install Left Side Swingarm Bearing (typical) . Position Removal Cup against outer 1. See Figure 2-156 swingarm. 2. Remover/Installer. 3. 4. Install bearing and nut. 5.
sm03193 Right Side Bushi 1. See Figure 2-157. right arm of swingar 2. Install forcing screw 3. Install Bushing Re nut. 4. Tighten forcing sc swingarm housing. 5. Once bushing has b semble tool and re Discard old bushing ft Side Swingarm Bearing (typical) m Bearing Installation NOTE the point of seating the swingarm ge can result. Load new swingarm bearing onto remover/installer and insert into w through small hole in Bearing p against inner left arm of swingarm Figure 2-157. Remove Right Si ng swingarm. ut. ng screw finger tight. ce: Chassis de Bushing (typical)