HOME 2.40 REAR FENDER: ALL EXCEPT VRSCF REMOVAL 6. See Figure 2-168 . Remove electrical caddy and six fasteners and washers from fender. Remove fender from inner fender by lifting upward and sliding fender back. 5. See Figure 2-167 . Remove fasteners and passenger pil- lion. 2. Install rear shocks using shock mount nuts and tighten to 115-125 Nm (85-92 ft-lbs). sm03213 3. Install rear fender by sliding rear fender into slot on tail light panel and aligning fender with bolt holes on inner fender. 4. Install six fender fasteners. Tighten fasteners to 4.5-7.5 Nm (40-66 in-lbs ). 5. Install tail light. 6. Install passenger pillion and fasteners. Tighten fasteners to 20-26 Nm (15-19 ft-lbs). 7.
Install maxi-fuse. 8. Install right side cover. Figure 2-168. Fender Mounting Fasteners Be sure headlamp, tail and stop lamp and turn signals are operating properly before riding. Poor visibility of rider to other motorists can result in death or serious injury. (00478b) 9. Test tail light and signal function. 2009 VRSC Service: Chassis 2-113 1 2 sm03212 1. Fasten 2. Shock Figu 7. See Figure shocks an INSTALLA Figure 2-167. Remove Pillion 1. Install inne 110 Nm (7 er and washer mount nut re 2-169. Inner Fender Fasteners 2-169. Remove inner fender by removing rear d fasteners shown. TION 7. See Figure shocks an INSTALLA 1. Install inne 110 Nm (7 Figure 2-167.
Remove Pillion r fender and fasteners.Tighten fasteners to 95- 5-81 ft-lbs).