Cleaning and care Replacing the light bulbs Isolate the extractor hood by pulling out the mains plug or switching off the fuse. ❑ When cleaning the grease filters, remove grease deposits from accessible parts of the housing. This prevents the risk of fire and ensures that the extractor hood continues operating at maximum efficiency. ❑ Clean the extractor hood with a hot soap solution or a mild window cleaner. ❑ Do not scrape off dried-on dirt but wipe off with a damp cloth. ❑ Do not use scouring agents or abrasive sponges. ❑ Note: Do not use alcohol (spirit) on plastic surfaces, as dull marks may appear. Caution: Ensure that the kitchen is ade- quately ventilated. Avoid naked flames!
Clean the operating buttons with a mild soapy solution and a soft, damp cloth only. Do not use stainless-steel cleaner to clean the operating buttons. Stainless steel surfaces: ❑ Use a mild non-abrasive stainless steel cleaner. ❑ Clean the surface in the same direction as it has been ground and polished. Do not use any of the following to clean stainless steel surfaces: abrasive sponges, cleaning agents containing sand, soda, acid or chloride! Malfunctions Please contact customer service regarding any queries or malfunctions. (See customer-service directory). When calling, please quote: Aluminium and plastic surfaces: ❑ Use a soft, non-linting window cloth or micro-fibre cloth.
❑ Do not use dry cloths. ❑ Use a mild window cleaning agent. ❑ Do not use aggressive, acidic or caustic cleaners. ❑ Do not use abrasive agents. E-No. FD Enter the numbers in the above box. The numbers can be found on the rating plate – remove the grease filter inside the extractor hood to reveal the rating plate. 21 1. Switch off the extractor hood and isolate the extractor hood by pulling out the mains plug or switching off the fuse. 2. Remove the grease filter (see Filters and maintenance). 3. Replace the bulb (standard filament bulb, max 40 W, E14 bulb holder). 4. Re-insert the grease filters. 5. Reconnect the power by inserting the mains plug or by switching on the fuse.