No.20S025-02 8.15 Save and load camera settings The camera has camera setting save function, camera setting including factory default loads function. The camera has below two camera settings. Default: The factory default settings (This setting cannot change) UserSetX: Over writeable camera settings (X: 0 to 7) These camera settings load from ROM to register in RAM on camera and camera settings save to ROM. The camera settings saving and loading is controllable with Parameters (UserSetSelector, UserSetDefault), and commands (UserSetLoad, UserSetSave) in UserSetControl category of GenICam. The details of parameters and functions are in table below:
GenICam Parameters ROM UserSetX Camera Setting When UserSetSave is executing, the camera settings at register in RAM are saved to ROM that is selected at UserSetSelector. Caution: UserSetSave cannot execute when “Default” was selected at “UserSetSelector” ROM Default Selector UserSetSelector Setting Procedure 1. Selects “UserSetX” at “UserSetSelector” 2. Execute “UserSetSave” STC-MBS510CXP6 / STC-MCS510CXP6 Product Specifications and User’s Guide 36/49 UserSetSelector IEnumeration Type Select “Default” or ”UserSet1” UserSetLoad or UserSetSave process for selected settings. UserSetLoad ICommand Type The camera settings load from ROM to register in RAM.
UserSetSave ICommand Type The camera settings at register in RAM save to ROM. UserSetDefault IEnumeration Type Select which settings (“Default or UserSet X) load automatically when camera power is on. This selection saves automatically.