Brought to you by BirfMark − INTRODUCTION REPAIR INSTRUCTIONS IN−7 (7) When checking continuity at the wire connector, in- sert the tester probe carefully to prevent terminals from bending. (8) When using a vacuum gauge, never force the hose onto a connector that is too large. Use a step−down adapter for adjustment. Once the hose has been stretched, it may leak air. (m) Installation and removal of vacuum hose: (1) When disconnecting vacuum hoses, use tags to identify how they should be reconnected to. (2) After completing a job, double check that the vacu- um hoses are properly connected. A label under the hood shows the proper layout.
(n) Unless otherwise stated, all resistance is measured at an ambient temperature of 20 ° C (68 ° F). Because the resis- tance may be outside specifications if measured at high temperatures immediately after the vehicle has been run- ning, measurement should be made when the engine has cooled down. Example IN0002 1996 LAND CRUISER (RM451U) 7 Author : Date: Brought to you by BirfMark Version 1.11 - 03/16/2010