TRANSFER CASE - TOD 5D2-43 SSANGYONG Y200 Step Action Value Yes No 5 Connect a digital ohmmeter between each of the following TOD connector terminal and ground. • A9 (Ground) • A10 (Ground) Does the resistance of the all circuits measure within the value specified? 0 Ω Go to Step 7 Go to Step 6 6 Repair or replace any open or damaged circuit. Is the repair complete? - Go to Step 7 - 7 1. Disconnect the 7-pin connector under the body. 2. Measure the voltage between terminal 4 and ground. Is the resistance within the value specified? 0 Ω Go to Step 9 Go to Step 8 8 Repair open or short to battery circuit. Is the repair complete?
- System OK - 9 Measure the resistance between the clutch coil terminal H and ground. Is the measurement within the value specified? 2.2 ~ 2.8 Ω Go to Step 11 Go to Step 10 10 1. Replace EMC (Electronic Magnetic Clutch). 2. Connect all the connectors. 3. Connect a scan tool to the DLC. 4. Turn the ignition switch to ON. 5. Delete and request DTC. Is the repair complete? - System OK - 11 Replace TOD. Is the repair complete? - System OK -