TRANSFER CASE - TOD 5D2-47 SSANGYONG Y200 Step Action Value Yes No 4 1. Repair any damaged pins, terminals, short to battery circuit. 2. Reconnect the connectors and make sure it is seated properly. 3. Connect a scan tool to the data link connector (DLC). 4. Turn the ignition ON. 5. Request the DTC with scan tool. Is the DTC still current? - Go to Step 5 System OK 5 Measure the resistance between terminals of the male white 7-pin connector. Is the measurement within specified range? • Terminal B and terminal C • Terminal B and terminal D • Terminal C and terminal D 5 ~ 6 MΩ 5 ~ 6 MΩ 9 ~ 10 kΩ Go to Step 7 Go to Step 6 6 Replace front propeller shaft speed sensor. Is the repair complete?
- System OK - 7 1. Replace the TOD. 2. Turn the ignition switch to OFF. 3. Connect the scan tool to data link connector (DLC) and follow the directions given in the scan tool manual. 4. Turn the ignition switch to ON. 5. Delete and request DTC with scan tool. Is the repair complete? - System OK -