F2B ENGINE 65 T RAKKER E URO 4/5 Selection of connecting rod half-bearings (rectified pins) If pins have been rectified, the procedure described must be applied. In this case, (for each undersizing) determine the tolerance field the new big end pins belong to, and install the half-bearings identified according to the relative table.
Figure 79 red/black = mm 2.074 to 2.083 -0.127 green/black = mm 2.063 to 2.073 1 2 3 72.789 72.798 1 green/black green/black green/black green/black green/black green/black 72.799 72.808 2 red/black green/black green /black red/black green/black green/black 72.809 72.818 3 red/black red/black green/black red/black red/black green/black -0.254 red mm 2.127 to 2.137 1 2 3 green = mm 2.138 to 2.147 72.671 72.680 red green green red green green 72.681 72.691 red red green red red green -0.508 red = mm 2.254 to 2.264 1 2 3 green = mm 2.265 to 2.274 72.417 72.426 red green green red green green 72.427 72.437 red red green red red green Print 603.93.641 Base q November 2006