F2B ENGINE 115 T RAKKER E URO 4/5 PRINT603.93. 641 Figure 228 Lubricate bushing ( actuator (1) to turbocompressor Connect tie rod (3) to lever (8). Mount new ring (4), mount Screw up screws (2) turbocompressor (7). Tighten screws (2 and 6) at Checking actuator travel Figure 229 Check travel X of tie rod (2) follows. Measure distance X1 between actuator eyelet (4). Apply, to fitting of actuator modulating it,from 0 of travel. Measure again the distance cross-axis of eyelet (4) Travel X of tie rod (2) of actuator subtraction X = X2-X1 and 11.5 0.5 mm.
Print 603.93.641 Base q November 2006 106229 d (3) and pin ( ) of lever (8) GREASE type and reconnect or (7) operating as follows. 8). k (5) and screw up screw (6). ecuring actuator (1) to Nm torque. el Cleaning turbine body Figure 230 106231 Mark mounting position of clamp (2) on central body (1). On threading and nut (4), apply antioxidant spray lubricant and, operating on nut (4), loosen clamp (2). Slightly rotate clamp (2) using pliers (5). Mark mounting position of turbine body (3) on central body (1). Figure 231 106232 By a copper hammer, beat on two opposite points (~180º) on turbine body (2) to separate turbine body from central body (1).
NOTE In operation,take particular care to avoid damaging turbine rotor. After dismounting turbine body, check variable geometry movement as described in relating chapter; where improvement in movement is not found with respect to previous check, replace turbocompressor. 106230 of actuator (1) operating as actuator (1) and cross-axis of piping (3) for compressed air gulator. By using the pressure tor (1) compressed air slowly ntil lever (5) is takento its end between actuator (1) and sion X2. ator (1) is given by following must result to be equal to