196 F3B ENGINE T RAKKER E URO 4/5 Mountingthe connectingrod qpiston assembly Mounting the piston rings Figure 122 Figure 124 60614 To fit the piston rings (1) on the piston (2) use the pliers 99360184 (3). The rings need to be mounted with the word yTOPy (4) facing upwards. Direct the ring openings so they are staggered 120 apart. 73536 The piston (1) has to be fitted on the connecting rod (2) so that the graphic symbol (4), showing the assembly position in the cylinder liner, and the punch marks (3) on the connecting rod are observed as shown in the figure.
Fitting the big end bearing shells Figure 125 Figure 123 1 2 3 49030 74052 Fit the bearing shells (1), selected as described under the heading ySelecting the main and big end bearing shellsy, on both the connecting rod and the cap. If reusing bearing shells that have been removed, fit them back into their respective seats in the positions marked during removal. Fit the pin (2) and fasten it on the piston (1) with the seeger rings (3). Base q November 2006 Print 603.93.641