F3B ENGINE 237 T RAKKER E URO 4/5 5424 TURBOCHARGING The turbocharging system is composed of: - an air filter; - A turbocharger with fixed geometry and WASTEGATE (410 HP engines) or with variable geometry for 450 HP/500 HP engines; - an kintercoolery radiator. Figure 240 Engine exhaust gas Compressed air (hot) Intake air Compressed air (cooled) 71737 TURBOCHARGING DIAGRAM Turbocharger HOLSET HE 551 V Working principle The movement of the device changing the cross-section of theflow ofexhaust gases is accomplished with a mechanism operated by a pneumatic actuator.
The variable geometry turbocharger (VGT) is composed of a centrifugal compressor and a turbine equipped with a mobile device that, by changing the area of cross-section of the passage of the exhaust gases going to the turbine, governs the speed. This actuator is controlled directly by the electronic control unit via a proportional solenoid valve. This device is most closed at low speed. At high engine speeds, the electronic control system increases the cross-section of the passage to permit the incoming gases to flow without increasing their speed too much. Thanks to this solution, it is possible to keep the speed of the gases and turbine high even when the engine is running at low speed.
Cast in the central body there is a toroidal chamber for the coolant to pass through. By making the gases pass through small cross-sections, they flow faster, so that the turbine turns faster as well. Print 603.93.641 Base q November 2006